Seongkyun Kim , Taeyeop Kim , Jaehyun Sung , Yongjun Kim , Dongwoo Lee and Seunghyun BaikMaterials Horizons
Thermal rectification is an asymmetric heat transport phenomenon where thermal conductance changes depending on the temperature gradient direction. The experimentally reported efficiency of thermal rectification materials and devices, which are applicable for a wide range of temperatures, is relatively low. Here we report a giant thermal rectification efficiency of 218% by maximizing asymmetry in …
C. MUHAMMED AJMAL, SEOKJAE CHA, WONJOON KIM, K. P. FASEELA, HEEJUN YANG, AND SEUNGHYUN BAIKScience Advances
The dependence of the electrical resistance on materials’ geometry determines the performance of conductive nanocomposites. Here, we report the invariable resistance of a conductive nanocomposite over 30% strain. This is enabled by the in situ–generated hierarchically structured silver nanosatellite particles, realizing a short interparticle distance (4.37 nm) in a stretchable silicone rubber matr…
K. P. Faseela, C. Muhammed Ajmal, Seokjae Cha, Seunghyun BaikAdvanced Functional Materials
Copper (Cu) is an attractive low-cost alternative to silver or gold. However, it is susceptible to oxidation in air. Here, facile in situ regeneration of oxidized Cu flakes (CuFLs) for the synthesis of highly conductive non-oxidized nanocomposites is reported. The oxidized CuFLs are regenerated into non-oxidized CuFLs and Cu nanosatellite (CuNS) particles by formic acid-aided in situ etching and r…
Shabas Ahammed Abdul Jaleel, Taehun Kim, Seunghyun BaikAdvanced Materials
Phase-change materials (PCMs) have received considerable attention to take advantage of both pad-type and grease-type thermal interface materials (TIMs). However, the critical drawbacks of leaking, non-recyclability, and low thermal conductivity (κ) hinder industrial applications of PCM TIMs. Here, leakage-free healable PCM TIMs with extraordinarily high κ and low total thermal resistance (Rt) are…
We investigated electrical conductivity and Vickers hardness of Ag- and Ni-based composites prepared by powder metallurgy involving spark plasma sintering. The starting composition was Ag:Ni = 61:39 vol%, which provided an electrical conductivity of 3.30 × 105 S cm−1 and a hardness of 1.27 GPa. The addition of bare multi-walled carbon nanotubes (MWNTs, 1.45 vol%) increased hardness (1.31 GPa) but decreased electrical conductivity (2.99 × 105 S cm−1) and carrier mobility (11 cm2 V−1 s−1) due to the formation of Ni3C in the interface between the MWNTs and Ni during spark plasma sintering. The formation of Ni3C was prevented by coating the surface of the nanotubes with Ag (nAgMWNTs), concomitantly increasing electrical conductivity (3.43 × 105 S cm−1) and hardness (1.37 GPa) of the sintered specimen (Ag:Ni:nAgMWNTs = 59.55:39:1.45 vol%). The electrical contact switching time (133 357) was also increased by 30%, demonstrating excellent feasibility as electrical contact materials for electric power industries.
