Seongkyun Kim , Taeyeop Kim , Jaehyun Sung , Yongjun Kim , Dongwoo Lee and Seunghyun BaikMaterials Horizons
Thermal rectification is an asymmetric heat transport phenomenon where thermal conductance changes depending on the temperature gradient direction. The experimentally reported efficiency of thermal rectification materials and devices, which are applicable for a wide range of temperatures, is relatively low. Here we report a giant thermal rectification efficiency of 218% by maximizing asymmetry in …
C. MUHAMMED AJMAL, SEOKJAE CHA, WONJOON KIM, K. P. FASEELA, HEEJUN YANG, AND SEUNGHYUN BAIKScience Advances
The dependence of the electrical resistance on materials’ geometry determines the performance of conductive nanocomposites. Here, we report the invariable resistance of a conductive nanocomposite over 30% strain. This is enabled by the in situ–generated hierarchically structured silver nanosatellite particles, realizing a short interparticle distance (4.37 nm) in a stretchable silicone rubber matr…
K. P. Faseela, C. Muhammed Ajmal, Seokjae Cha, Seunghyun BaikAdvanced Functional Materials
Copper (Cu) is an attractive low-cost alternative to silver or gold. However, it is susceptible to oxidation in air. Here, facile in situ regeneration of oxidized Cu flakes (CuFLs) for the synthesis of highly conductive non-oxidized nanocomposites is reported. The oxidized CuFLs are regenerated into non-oxidized CuFLs and Cu nanosatellite (CuNS) particles by formic acid-aided in situ etching and r…
Shabas Ahammed Abdul Jaleel, Taehun Kim, Seunghyun BaikAdvanced Materials
Phase-change materials (PCMs) have received considerable attention to take advantage of both pad-type and grease-type thermal interface materials (TIMs). However, the critical drawbacks of leaking, non-recyclability, and low thermal conductivity (κ) hinder industrial applications of PCM TIMs. Here, leakage-free healable PCM TIMs with extraordinarily high κ and low total thermal resistance (Rt) are…
Here we present a new strategy of selectively rejecting water vapor while allowing fast transport of dry gases using temperature-controlled aligned-multiwalled carbon nanotubes (aligned-MWNTs). The mechanism is based on the water vapor condensation at the entry region of nanotubes followed by removing aggregated water droplets at the tip of the superhydrophobic aligned-MWNTs. The first condensation step could be dramatically enhanced by decreasing the nanotube temperature. The permeate-side relative humidity was as low as ∼17% and the helium–water vapor separation factor was as high as 4.62 when a helium–water vapor mixture with a relative humidity of 100% was supplied to the aligned-MWNTs. The flow through the interstitial space of the aligned-MWNTs allowed the permeability of single dry gases an order of magnitude higher than the Knudsen prediction regardless of membrane temperature. The water vapor separation performance of hydrophobic polytetrafluoroethylene membranes could also be significantly enhanced at low temperatures. This work combines the membrane-based separation technology with temperature control to enhance water vapor separation performance.
